Assistance please.

[negrete35]

Hello to all the great modders out there. I would like to ask for some help. I would like to make a pass through with multiple dna 20 boards for my beer pong nights. Hehe. I could probably just make it with multiple batteries, but is there anyway to make a true pass through and have the power supply power multiple chips? Any thoughts and help would be greatly appreciated.

Sent from my SAMSUNG-SGH-I537 using Tapatalk

 

[retird]

I'm sure it could be possible. How many chips are you thinking of running and will the wattage adjustment/display need to be hand held at a distance from the power supply?

The term "true pass through" is probably not the right term. I'm thinking you are wanting to regulate the proper power/voltage to multiple auxiliary DNA20d chip devices, with the power being supplied by only one power supply, without using batteries.

You might contact somebody at this link and explain your output voltage/amperage needs to them.....

http://www.trcelectronics.com/power-supply.shtml

Here is an example: https://www.trcelectronics.com/ecomm/pdf/hrp150.pdf

Note: I'm thinking that each chip connected to a large power supply should be protected with an in-line fuse rated at 7 amps.

 

[negrete35]

Thanks. I would like to just be able to put a DNA 20 into a handle with the 510 connector. Then have it wired to a base that is plugged into the wall. If I could make 2 or 3 handles that would be great.

Sent from my SAMSUNG-SGH-I537 using Tapatalk

 

[Carl_H]

negrete, you should take a look at the Hooka in my shop. it is basically what you are looking to do with a hose and handle for your atomizer but the chip is in the barrel on the table. I know that that device can have up to 6 hoses added. if you want to open it to see inside we can do that.

 

[negrete35]

Thanks Carl. I will do that.

Sent from my SAMSUNG-SGH-I537 using Tapatalk