Atomic RDA (Clone) Flavor Setup?

[Luke49783]

Hey Folks,

I recently purchased the EHPro Atomic clone after hearing rave reviews on it regarding flavor. I'm coming from using an Igo-W4 (mostly) and a Stillare clone (once in a while). I've got the Atomic setup with dual 26ga micro coils at about 0.4 ohms. My Igo is set up at about 0.6 ohms with dual 28ga micro coils. Both are using organic cotton wicks.

I'm not finding the flavor with the Atomic to be as mind blowing as I had expected. I would say that it's possibly not even as good as the Igo. The Igo has stock air holes and I've been using the 2mm air hole on the Atomic. I tried the 1.5mm holes, but didn't notice an improvement, plus it ended up being too hot.

Does anyone have suggestions on how to get the most flavor out of the Atomic?

 

[MrOcelot]

I leave my atomic on the biggest hole but close it just a little. It's more flow than the secon hole but not as wide open. This helps the flavor to shine a little more.

 

[Etherz]

I usually run mechs but I like to run my atomic single coil at 1.5 ohm at 20watts.
I noticed the smaller the chamber the less I want to sub ohm.

Sent from my SM-N900P using Tapatalk

 

[Steamer861]

Try the same setup as your igo and compare apples to apples