I have a cool fire 4 with a T3S Kangertech tank, using what's suppose to be a 1.8 ohm atty. My cool fire reads either 1.99 or 2.05 ohms is this normal. They are fresh out of the package too.
Atomizer ohm level fluctuates
- Thread starter polarbearted
- Start date
- th_trl_thread_readers 0
- Status
Moved to Clearomizers from Atomizers and Cartridges
Atomizers and Cartridges
A forum for general discussion of atties and carts (atomizers and cartridges).
Atomizers and Cartridges
A forum for general discussion of atties and carts (atomizers and cartridges).
Some variation is to be expected with factory made atomizer heads as they are made for pennies . Also the resistance meters in mods are not always 100% accurate. If the resistance is actually fluctuating during use, then you may have a loose or bad connection somewhere. Clean tighten and adjust accordingly.
Stock coils seem to do that with aspire and kanger. It's not a big deal on my nautilus' as there is very little difference in performance from 1.8 to 2 ohm. It annoys me on my subtanks though because there is a world of difference between even a .5 to a .6ohm reading.
Not that their .5ohm stuff ever read that low. They always start at like 1 and then after you fire them a few times will drop to .6 or .7
Just another reason I like the rba section. If I build it to 0.5 that's what it stays at unless it gets dropped or something.
Not that their .5ohm stuff ever read that low. They always start at like 1 and then after you fire them a few times will drop to .6 or .7
Just another reason I like the rba section. If I build it to 0.5 that's what it stays at unless it gets dropped or something.
- Status
Similar threads
