Atomizer Question

[Slappy369]

I have been vaping for two months but I was only using cartomizers. I just got my first atomizer for my Provari for the sole reason of trying different juices.

Here is my question. After I drip into my atomizer with say "555", can I take take 6 or 7 puffs until it loses flavor and then drip in "cherry"? Or should I clean the atomizer first for a "clean slate"?

If I should clean the atomizer before switching juices what is the best way to go about it?

Thanks,
Slappy

 

[Incognito™]

Nah you don't have to clean it.

 

[Trioxin]

I change flavors on the fly all the time. It will usually take a couple of runs through the new liquid to get the old flavor out though. Some strong flavors like clove or menthol normally get their own atomizer or a thorough cleaning before switching flavors.

 

[hairball]

You can either clean it by using pure grain alcohol or vodka, blow out, and do a short dry burn....or....buy a bottle of unflavored vg from wal-mart, add a couple drops, vape it off, and change flavors.

 

[Gimpy8877]

I just keep on dripping as long as it is not too strong of a flavor or the flavors don't go well together. Cherry + tobacco should be fine or menthol + tobacco, but you dont want to do menthol then switch to chocolate cake.

 

[Slappy369]

I just keep on dripping as long as it is not too strong of a flavor or the flavors don't go well together. Cherry + tobacco should be fine or menthol + tobacco, but you dont want to do menthol then switch to chocolate cake.

I got a lot of different trial bottles from blue mist vaping. I'm looking for a couple of flavors that I can use as my main vapes. They will be used with a liquinator on a provari.
So basically I just want to be able to taste each one.

 

[Slappy369]

You can either clean it by using pure grain alcohol or vodka, blow out, and do a short dry burn....or....buy a bottle of unflavored vg from wal-mart, add a couple drops, vape it off, and change flavors.

vg from walmart?? didn't know they sold that kind of stuff. As soon as my wife wakes up I know where I am going.

 

[carpedebass]

Not a dripper, but I think I'd want a clean palette prior to trying any new juices...+1 for VG cleansing.

 

[Creniker]

The easiest way Imo would be when the flavor runs out, press the button for like three sec, and burn off an excess flavor. Then drip your next flavor. Sometimes it takes more then a three sec dryburn, but im sure you get the pic.

 

[JustaGuy]

You can also run the atty through hot water, blow out and burn dry, just evaporate the water, but don't over burn to pop atty. When I was testing flavors, I wanted the purest flavor and longer tests. Sometimes, a flavor takes a while to catch on with the taste buds, so I would vape one flavor for half a day before starting fresh.

 

[Liv2Ski]

hairball has provided good advice. For testing flavors you really want an atty to have as little of the previous flavor as possible. I use want2vapes atty renew but plain Vg or Pg works too. Blow the excees liquid form the previous flavor out. Put some non flavored liquid in and blow that out. Cigar puff a hit or two then prime atty with new flavor and go to town. While the dry burn will work it is also stressfull on the coil and if you are trying 1/2 dozen flavors or so back to back you will most likely shorten the atty life. Also note that from my experience I have several juices that I like on an atty but that suck in a carto/tank and vice versa. Good luck experimenting and remember that finding a flavor with a cig was not nearly as fun as this!!! Happy vapes