i have finally scored a raptor atty from the latest batch which has two pins, one (installed) is a bottom fed pin and one that is a sealed pins. i want the swap them and i can't figure it out. i started using pliers and either it's really in there or i am missing something. Before i do something stupid and cause damage to the atty i was hoping someone might know what i need to do. i wont be receiving my new squonker for around a month i wanna set this up to drip with for the time being. any help would be appreciated.
RDA Attysmith Hellfire Raptor question
- Thread starter KalThaxx
- Start date
- th_trl_thread_readers 0
- Status
My hellfire short cranked bottom feed has an allen socket in the bottom of the center pin to screw it out. Not sure if they're the same.
- Status
Similar threads
- Locked
- Locked
