AW IMR fast dropoff?

Status
Not open for further replies.

DeadPerfect

Super Member
ECF Veteran
Verified Member
Dec 24, 2011
306
97
RI
i'm using a Silver bullet till my Vamo arives.. been using the black AW IC 18650 protected batteries with it as suggested when purchaced. they work fine. but recently learned the AW IMR's will output more power, which it does. and thats great. i get a better hit from the SB. but after a 1/2 hour, i start getting weak hits, so i toss it back in the charger, and throw in a protected battery while it tops off again. and the hits after a 1/2 hour are alot weaker than the charged protected battery.

is this normal with AW IMR in a non vari-volt mod? or do i possible have a bad battery? got it from RTD Vapor. thanks
 

WillyB

Vaping Master
ECF Veteran
Oct 21, 2009
3,709
591
USA
is this normal with AW IMR
Yup. Unless you have an extreme need for a high discharge rate the Li-Ion's mAh trumps the IMR.

Here it is visually.

AWIMR_LI-ION.png
 

MattB101

Ultra Member
ECF Veteran
Jul 9, 2012
2,560
74,146
67
Deerfield Beach, FL
When fully charged the battery voltage is around 4.2 volts. Normal working voltage is 3.7 volts. Most batteries will drop from the fully charged voltage (4.2) to somewhere around the working voltage (3.7) fairly quickly. Once near the working voltage (3.7) the discharge rate slows down and the battery will maintain something close to it while slowly dropping till it hits the recharge voltage. If you are sensitive to the strength of the "hit" you will notice this fast dropoff in voltage then it will maintain the same "hit" strength until nearly the recharge voltage then drop off quickly again. This is one of the things that the variable voltage/wattage mod was designed to fix.
thanks.. but a 1/2 hour, moderate vaping? doesnt seem right. black one goes hours b4 any noticeable dropoff...
 

WillyB

Vaping Master
ECF Veteran
Oct 21, 2009
3,709
591
USA
After about 90 minutes of resting, the battery will drop to close to its working voltage without any use.

Using it, it happens a lot faster.

Have no idea what "working voltage" means. Our batteries are sold and labeled by their nominal voltage, usually 3.7V, which is more or less an average over the life of the charge. If you have a battery that comes off the charger at 4.2V and after a simple rest drops below 4V you might as well toss it and get a new one. That's assuming only that one battery does that.

That said pulling a battery off the charger early can also show similar results. The charger actually terminates based on current. BatteryU uses the term full saturation.
 
Status
Not open for further replies.

Users who are viewing this thread