Bachelor RTA and temperature vaping

[Ongeslepen]

For some reason i am not able to make a correct TC build on this tank. Today i checked the resistance of the coil that i made on all my mods... here are my findings

RX200 0.85Ω
Cuboid 0.91Ω
VTC mini 0.67Ω
coilmaster 0.68Ω

The VTC and the coilmaster are reading the resistance correct. But the other 2 are just way off...
Any idea what i can do to fix this problem? I cleaned the 510 with some tissue paper, no idea what else i can do. All my other tanks i have no problem making a proper tc build.

I use SS316L wire.

 

[Two_Bears]

What about the formula in the chip to read the resistance? Or even the wiring in the mod?

Maybe the 510 pin is throwing off the resistance

Are yoy surre yoy allowed the coil to return to room Temperature?

 

[Ongeslepen]

What about the formula in the chip to read the resistance? Or even the wiring in the mod?

Maybe the 510 pin is throwing off the resistance

Are yoy surre yoy allowed the coil to return to room Temperature?

I'm positive, i tested it various times just screwing the tank on the mods without firing it. If i grab any other tank, all the mods do read the same resistance. It's only the bachelor tank who has issue's with the rx200 and the cuboid

 

[Two_Bears]

I'm positive, i tested it various times just screwing the tank on the mods without firing it. If i grab any other tank, all the mods do read the same resistance. It's only the bachelor tank who has issue's with the rx200 and the cuboid

Try again with the coil at room Temperature.

Thus time do the two you assume to be way off.

 

[Ongeslepen]

Try again with the coil at room Temperature.

Thus time do the two you assume to be way off.

tested it again... it's the same as this morning. Now i just noticed that the 510 connection of the bachelor is a bit shorter then my other tanks... I think that's it... Mystery solved...

but unfortunately no fix... is there anyway i can extend the 510? by adding a piece of material in between or something?

 

[Cirus]

tested it again... it's the same as this morning. Now i just noticed that the 510 connection of the bachelor is a bit shorter then my other tanks... I think that's it... Mystery solved...

but unfortunately no fix... is there anyway i can extend the 510? by adding a piece of material in between or something?

From The Thread

The 510 is really short on the Bachelor and Nano. It's not a problem on my Nuggets but I had to rig up the 510 to make it work with my Evic VT.

If needed; you can pull out the copper (or is it brass?) 510 pin out of the base and put a little shim underneath that. I used a really thin piece of copper wire that I flattened and cut to size. Just put it in the hole and stick the pin back on top of it.

 

[Two_Bears]

tested it again... it's the same as this morning. Now i just noticed that the 510 connection of the bachelor is a bit shorter then my other tanks... I think that's it... Mystery solved...

but unfortunately no fix... is there anyway i can extend the 510? by adding a piece of material in between or something?

Glad you found the issue

 

[Ongeslepen]

Thx for the support guys!