Battery Tests

Status
Not open for further replies.

BuzzKill

Unregistered Supplier
ECF Veteran
Nov 6, 2009
7,412
5,145
65
Central Coast Ca.
www.notcigs.com
This last batch was not so good ! < I have been buying these same batts for over a year and never had any problems ! , the New Powerizer ones are a USA battery ( made In China , but tested here ) and so far have been great ! , sorry for any issues I did not even know there was a problem until I got the analyzer .

NOW we know wth we are getting and what the hell I am selling ! , from this point one I will batch test the batts so I know they are OK !
 

moorea

Unregistered Supplier
ECF Veteran
Aug 11, 2009
6,868
7,355
55
Marion, MT
phiniac.com
This last batch was not so good ! < I have been buying these same batts for over a year and never had any problems ! , the New Powerizer ones are a USA battery ( made In China , but tested here ) and so far have been great ! , sorry for any issues I did not even know there was a problem until I got the analyzer .

NOW we know wth we are getting and what the hell I am selling ! , from this point one I will batch test the batts so I know they are OK !

Lets look at it on the bright side... now that we used some from the bad batch, we can all really appreciate this new battery!
 

BuzzKill

Unregistered Supplier
ECF Veteran
Nov 6, 2009
7,412
5,145
65
Central Coast Ca.
www.notcigs.com
Lets look at it on the bright side... now that we used some from the bad batch, we can all really appreciate this new battery!

Really it seems that some of the new ones are much lower in capacity then the previous batches ! unfortunately I do not have OLD ones to test against ! .

The NEW Powerizers and the others listed as GOOD ! / tested GOOD are all OK so far , as always with stuff from China this could vary from batch to batch as we know .
 

Baldr

Ultra Member
ECF Veteran
Verified Member
Jul 14, 2011
1,391
1,671
Dallas, Tx
I'm trying to figure out what batteries to get when I order a Buzz Pro. But I must admit, this thread leaves me fairly confused. I don't know anything about batteries or mah or amps or whatever.

As best I can tell, these are recommended as the best for the Buzz Pro, however, they are not protected. I'd rather have protected batteries. Is there a better option?

Powerizer Rcr123a 3.7 volt real 650 mah Buzz battery - notcigs.com

Also, what batteries come with it if you order the battery/charger kit with the buzz pro? On the Buzz Pro page, it says they are 16340's, but I don't find 16340's being sold on the site anywhere else.
 

Modrod.

Vaping Master
ECF Veteran
Sep 30, 2010
8,061
33,357
50
AZ, USA
I'm trying to figure out what batteries to get when I order a Buzz Pro. But I must admit, this thread leaves me fairly confused. I don't know anything about batteries or mah or amps or whatever.

As best I can tell, these are recommended as the best for the Buzz Pro, however, they are not protected. I'd rather have protected batteries. Is there a better option?

Powerizer Rcr123a 3.7 volt real 650 mah Buzz battery - notcigs.com

Also, what batteries come with it if you order the battery/charger kit with the buzz pro? On the Buzz Pro page, it says they are 16340's, but I don't find 16340's being sold on the site anywhere else.
The Buzz has tons of internal protection built in so protected batteries in this mod is unnecessary. The link below gives some details on the protection features.

http://www.e-cigarette-forum.com/forum/notcigs/146738-new-technology.html
 

BuzzKill

Unregistered Supplier
ECF Veteran
Nov 6, 2009
7,412
5,145
65
Central Coast Ca.
www.notcigs.com
I'm trying to figure out what batteries to get when I order a Buzz Pro. But I must admit, this thread leaves me fairly confused. I don't know anything about batteries or mah or amps or whatever.

As best I can tell, these are recommended as the best for the Buzz Pro, however, they are not protected. I'd rather have protected batteries. Is there a better option?

Powerizer Rcr123a 3.7 volt real 650 mah Buzz battery - notcigs.com

Also, what batteries come with it if you order the battery/charger kit with the buzz pro? On the Buzz Pro page, it says they are 16340's, but I don't find 16340's being sold on the site anywhere else.

For the BEST battery charge times get the Powerizer ones ( they do not come in the kit yet ! ) the ones in the kit are the old UF 16340 ( or rcr123a , same thing sorry confusing I know ! ) they run about 1/2 the charge time and are cheaper , we will be phasing these out soon for the better Powerizers or something similar that have GOOD test results .
 

moorea

Unregistered Supplier
ECF Veteran
Aug 11, 2009
6,868
7,355
55
Marion, MT
phiniac.com
Well when I say similar nor they are TESTED and I will have the results compared to the Powerizers so you and I will know !!!!!!

If you say a battery is good I will take your word for it.

In the future when you are posting test results like that you should put some kind of warning on the post, that the attachment is only for those that are technically inclined, so someone like me doesn't accidently click on it and get all confused. :confused::blush:
 

BuzzKill

Unregistered Supplier
ECF Veteran
Nov 6, 2009
7,412
5,145
65
Central Coast Ca.
www.notcigs.com
If you say a battery is good I will take your word for it.

In the future when you are posting test results like that you should put some kind of warning on the post, that the attachment is only for those that are technically inclined, so someone like me doesn't accidently click on it and get all confused. :confused::blush:

LOL nice one Moo !

the farther the line goes to the right the better the battery on the chart OK ?
 

Baldr

Ultra Member
ECF Veteran
Verified Member
Jul 14, 2011
1,391
1,671
Dallas, Tx
I must admit, it feels odd that the "best" batteries are unprotected, since I'm told over and over to only use protected batteries. It also feels odd that the batteries are 650 mah. My ego batteries are 1,000 mah, and since I expect to be vaping at 5 volts or so, instead of 3.2 or whatever that the ego uses, it isn't what I'd expected.

But I'm seeing people talking about going 2-3 days before they have to recharge, so I guess it all works out.

I assume that a set of Powerizer batteries can be recharged with the charger that comes with the Buzz Pro?
 

moorea

Unregistered Supplier
ECF Veteran
Aug 11, 2009
6,868
7,355
55
Marion, MT
phiniac.com
LOL nice one Moo !

the farther the line goes to the right the better the battery on the chart OK ?

NO!!! Don't go and try to explain it! I don't want my head to explode. I spent the day creating a database, I don't think I fit anything else technical in there.

Besides, that is what the hubby is for. I would of asked him when you posted it, but he was off camping. If you explain these things to me, then he won't have a purpose.

As stated earlier, I am happy to just take your word for it!
 

moorea

Unregistered Supplier
ECF Veteran
Aug 11, 2009
6,868
7,355
55
Marion, MT
phiniac.com
I must admit, it feels odd that the "best" batteries are unprotected, since I'm told over and over to only use protected batteries. It also feels odd that the batteries are 650 mah. My ego batteries are 1,000 mah, and since I expect to be vaping at 5 volts or so, instead of 3.2 or whatever that the ego uses, it isn't what I'd expected.

But I'm seeing people talking about going 2-3 days before they have to recharge, so I guess it all works out.

I assume that a set of Powerizer batteries can be recharged with the charger that comes with the Buzz Pro?

Yup, the charger that comes with the pro is fine.

These are lasting so much longer on my Buzz Pro at about 5 volts then the ego batteries lasted vaping the same ml's per day.

As for the protection, I don't claim to know anything about that, I just take Buzz's word for it, he hasn't steered me wrong yet!
 

Baldr

Ultra Member
ECF Veteran
Verified Member
Jul 14, 2011
1,391
1,671
Dallas, Tx
Well, I think I'm convinced. I do like the idea of the on/off switch, and I'm told that new bottom caps should be in soon that have a switch built into them, so I think that's all I'm waiting on. Once those are available, I expect to order.

If they take very long coming in, maybe I'll be able to come up with enough extra cash to get the wood veneer. :)

Initially, I will use the same atomizer/cartomizer stuff I'm already using on my ego. I'll have to pick up an adapter to do that.

Later, I think I'll be adding a liquinator from Vaporesence, and I think that should get me where I want to go.

Thanks for the advice.
 
Status
Not open for further replies.

Users who are viewing this thread