Be510

[brandon555]

Best atty ever for 5+ volt vaping.

Tons of vapor, doesn't heat up fast like a Bauway or Joye

And best of all they dont leak all over.

 

[SKYYcamel]

Is there a US vendor that sells these?

 

[mwa102464]

Brandon can you put a pic up of this Atty for us????

 

[Col. Gaunt]

I just got in an order of 40 of them. I will be set for a while! BE Rocks!

 

[ejoker]

col gaunt, what resistance are these?

 

[Col. Gaunt]

col gaunt, what resistance are these?

I just got the regular ones, probably like 3.7 I am not home right now so I can't measure and tell you for certain.

 

[Col. Gaunt]

Wait, what the heck am I saying, not 3.7 more like 2.2

 

[gashin]

Sounds like a winner - I tried one of these and thought they were decent but am wondering about the reliability at 6V.

 

[Col. Gaunt]

Sounds like a winner - I tried one of these and thought they were decent but am wondering about the reliability at 6V.

You would use a hv at 6v not a be

 

[brandon555]

my multimeter says 3 ohms. Vaporspot.com has them for 7.50 a pop. Otherwise bestecig.com is cheaper but theyre out of china. Sorry for the crappy capitalization im on my cell at work

 

[Col. Gaunt]

col gaunt, what resistance are these?

Just measured one of the BE510s and it was 3.1 ohms. My first statment was closer to being correct.

 

[Convoy]

I don't like them, they work great when they work!!!

The problem with them, that i always have with them, is the rubber/silicon ring there is in the connection, it always go loose or or simply go off completely, and there by short circuit the atomizer.

I have never burnt BE510 atomizer dead, it has away been the rubber/silicon ring for me.

 

[brandon555]

I don't like them, they work great when they work!!!

The problem with them, that i always have with them, is the rubber/silicon ring there is in the connection, it always go loose or or simply go off completely, and there by short circuit the atomizer.

I have never burnt BE510 atomizer dead, it has away been the rubber/silicon ring for me.

Hmm... haven't had that problem yet with the BE... however that did happen to me with the Bauway 510. It came loose and the only way it would work on my PV was if it was threaded into it's sweet spot. Not too loose, not too tight... Got annoying so I tossed it.