BF Mods by Custom-Classic
- Thread starter custom-classic
- Start date
- th_trl_thread_readers 0
- Status
I am not sure what the correlation is, but that would be one large squonk hole.
Maybe I'm wrong. Just saying the design looks straight forward. Swap the positive pin for a FDV 2.5mm or 3mm bf pin. Cut to length with a dremel cutting wheel. Then drill a correlating hole in the positive block.
FDA BOC
Rule #1. Never tell a girl with a cannon she is wrong, in any way.
Rule #2. If'n you forget rule 1, make sure to be way out of range
Rule #2. If'n you forget rule 1, make sure to be way out of range
Rule #1. Never tell a girl with a cannon she is wrong, in any way.
Rule #2. If'n you forget rule 1, make sure to be way out of range
LOL!
I get what you are saying, and yes I am capable and usually prefer to do something myself rather than pay someone else. But when it comes to our vaping community, I would rather support our modders/vendors/suppliers and spend my time doing something else. Like cleaning black powder out of the tube.
Has nuclear war broken out yet?
Sent from my LG-H815 using Tapatalk
Sent from my LG-H815 using Tapatalk
Biggly!
I am going to have the classiest custom-classic ever! A top-notch mod engraver is going to lay hands on one of my aluminums
I am going to have the classiest custom-classic ever! A top-notch mod engraver is going to lay hands on one of my aluminums
Sounds drooley !
I can't wait to see it
I am going to have the classiest custom-classic ever! A top-notch mod engraver is going to lay hands on one of my aluminums
Been thinking about that same person I think.
- Status
