big problem with liquid!

Status
Not open for further replies.

WebMistress89

Super Member
ECF Veteran
Verified Member
Dec 14, 2011
578
707
36
Canada
www.rhiannagreene.com
Hello all...
I just ercived my e cigg kit finally and I filled a carto exactly as i was instructed to the way people do it when they put the liquid in the rubber cap and squish it down..

When I sucked on the tip liquid came out of it! So i scrubbed the crap outa my mouth right away and now im scared to use it.

It wasnt over full either.

the liquid gets like sucked out of the mouth peice
 

yzer

Vaping Master
ECF Veteran
Nov 23, 2011
5,248
3,870
Northern California
A drip tip can also provide a barrier between you and excess e-liquid in the carto.

I don't like the condom method for filling cartos. Remove carto from PV. Add liquid by dripping into the top of the carto. For a dry carto, add 6-10 drops turning the carto 1/3 revolution between drops. Wait 30 seconds and repeat. Add fewer drops, wait again for the fluid to soak in. Continue to fill, waiting to soak when the top of the filler looks like a slushie. Set the carto upright on a paper towel or kleenex while waiting for the soak. When juice runs out of the bottom onto the paper towel, the carto is filled. Dry off the atty end, blow though the carto onto the towel if you can't see light through the coil bore in the filler. Screw on the carto, replace the drip tip and you are ready to vape.
 

yzer

Vaping Master
ECF Veteran
Nov 23, 2011
5,248
3,870
Northern California
Another plus with drip-filling a carto... Darkened juice collects in the lower end of the carto. If you refill by dripping you will flush that stuff out with the overflow that runs down on the paper towel. If you bottom fill with the condom method that stuff just gets forced back up into the filler material, hastening the need to replace a stale, off-flavor carto.
 

36tinybells

ECF Guru
ECF Veteran
Apr 30, 2011
10,422
24,873
Right Over Here
Slide it in between the metal and the filler on the side away from the piece of metal wire you can see- if it's a thin needle you can go to the bottem without disturbing the filling much. I fill about a mil and move up abit and let the rest in. Go slow, stop when the top of the filler looks wet. Wait five or ten minutes, add a few drops more if it wicked down.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread