Blank 510 Mega Cartomizers
- Thread starter MXBNW
- Start date
- th_trl_thread_readers 0
- Status
I got a bunch of those blank 510 cartos back in June, and my initial impression was "Hoo-wee! Thatsa nice!" On the original fill-up, I placed 20 drops into the barrel, did a spin, and added 15 more and let it sit for an hour or so. The flavor and vapor was marvelous on a 5 volt pass-through, and I immediately considered ordering some more.
--- HOWEVER ---
The vape lasted about 3 hours when the taste and vapor production started to fall off, so I decided to reload. I couldn't get more than 12 drops into the barrel, and even after a spin, the filler was slushy. They'd only last about an hour from that point on, and most of them would only take 3 fills (10-12 drops) before they gave up entirely. Checking resistance on 3 of them showed 7-8 ohms after 4 uses.
Is anyone getting more life out of these?
--- HOWEVER ---
The vape lasted about 3 hours when the taste and vapor production started to fall off, so I decided to reload. I couldn't get more than 12 drops into the barrel, and even after a spin, the filler was slushy. They'd only last about an hour from that point on, and most of them would only take 3 fills (10-12 drops) before they gave up entirely. Checking resistance on 3 of them showed 7-8 ohms after 4 uses.
Is anyone getting more life out of these?
I haven't tried the Mega cartos yet but I am really liking the 801 cartomizers. I can get about 35 drops in one and they are lasting really well. The use the same drip tip as my 510. I will be ordering more.
Last edited:
I just ordered some blank 801 cartos for my Janty Stick i picked up, Drew through a few in when i ordered and it seams to work well.
Im getting way more life out of my cartos then the post below from FlyerTom.!!!
Drews 510 Cartos rock with taste and vapor especially the LR510's and the regular 510Cartos I use at 6v on one of my mods and they rock out as well, however at 5-6 volts you have to realize that these cartos are not made to run on these voltages in my opinion, the factory is making these for 3.7v. If you want to run Cartos at 5v-7v then you really should be purchasing the HV Cartos that are in the market place.!!!
Drews 510 Cartos rock with taste and vapor especially the LR510's and the regular 510Cartos I use at 6v on one of my mods and they rock out as well, however at 5-6 volts you have to realize that these cartos are not made to run on these voltages in my opinion, the factory is making these for 3.7v. If you want to run Cartos at 5v-7v then you really should be purchasing the HV Cartos that are in the market place.!!!
- Status
