I bought a bliss a few weeks back and like to vape 100% VG. The wick holes in the bliss seem to be small and when rolling the ss mesh it seems like the hole size is small and will not allow the VG to wick up and out. Don't seem to have this problem in others with bigger holes. Also I see allot of how to and they say they are using a 3/4 or even a 2/3 but when I do this I can never get over 1.0 ohms mostly less. I am using a provari and seems like I have to go to a real low voltage to make work. I have a few newer mods on the way that only use 3.7 volts so I am trying to get the volts up. Also what is the suggested use on a 2 wick set up as far as the wire and wraps to get the best vape?
Bliss wicking problems
- Thread starter Newlook
- Start date
- th_trl_thread_readers 0
- Status
One answer is to dilute the VG with DW so it is near the viscosity of a PG liquid.
Really thick, gloopy VG liquids may be problematic. I've never had a problem with wicking in any RTA or other kind of head, because my mixes are built to be fluid instead of gloopy. Not sure what the benefit of a thick, viscous VG mix is supposed to be, it doesn't seem a great idea.
Really thick, gloopy VG liquids may be problematic. I've never had a problem with wicking in any RTA or other kind of head, because my mixes are built to be fluid instead of gloopy. Not sure what the benefit of a thick, viscous VG mix is supposed to be, it doesn't seem a great idea.
- Status
Similar threads
