bobas bounty and kanger t3

[jonnyfalmouth]

can u use bobas bounty in a kanger t3 im asking because it is a vg liquid and thick????

 

[Kopfstimmen]

I haven't used either, but I would think you can... In a worst case, you can always clean it out again...

 

[jonnyfalmouth]

i ordered two of the t3s and a bottle of bobas bounty and gorrilla juice both 100% vg liquids can you thin the juice somehow?? Just wooried they wont wick properly

 

[Kopfstimmen]

Sorry, never tried thinning juices. I've heard of people using distilled water, but have never tried. I usually use a PG/VG mix myself. Maybe someone more knowledgeable can chip in?

 

[jonnyfalmouth]

well i recieved my T3s and my bobas and its working great so far no dry hits great flavor and vapor will have to see how it last i have only been using it a couple of hours cross my fingers lol

 

[wwturner]

well i recieved my T3s and my bobas and its working great so far no dry hits great flavor and vapor will have to see how it last i have only been using it a couple of hours cross my fingers lol

Any update on how Boba's is doing in your T3??

 

[youngstar]

I have Boba's and Kanger T3. It's a little too thick. It works but you have to wait a little bit between hits to let it soak in. I have another 10% PG from alien Visions also (the makers of Boba's Bounty). The 10% VG solution is much much thinner and you can puff on that non stop.

 

[bemo]

Just received my T3's and loaded one up with Boba's Bounty and another with a 50/50 mix. Both of them are stellar. The air bubble for the 50/50 definitely moves faster in the tank but there doesn't seem to be a wicking issue for me. Vaping both at 3.6V on a Ego Twist. I haven't played around with a bunch of gear, but this is the vaping experience I've been looking for. As for waiting in between hits...not sure about that. By the time I'm done enjoying one hit and watching the thick clouds roll away, it's ready for another so that's not an issue for me. VG is 100% water soluble, so adding a few drops of distilled water to it to thin it out wouldn't hurt. I'll try to report back after a few tanks, but right out of the box...amazing!

 

[cedric212]

T3 will work for Bobas but I prefer dripping or thinning it down with PGA to work with ViVi Nova (1-2 drop/3ml). The issues I'm having with T3 is:

1. cooler vape - changes the flavor of Bobas from gram cracker to plum juice (VV will only compensate so much)...
2. dry hit/flooding/draw balance - need to adjust # of "flavor wick" and air hole to prevent flooding/dry hit, an issue if you enjoy tight draw
3. PITA to rebuild the heads than VVN especially if you don't have a tweezer (an issue since Bobas gunk up the wick/coil fairly fast)

Personally, I enjoy a warm, tight, dense vape of Bobas that is full of flavor, and it's the above reasons that the T3 is currently is sitting in my drawl ATM. Will probably use it to build a Toddiod or try SS wick on it.

 

[Sentient_Meat]

I've tried the Boba's in a T3 and had trouble with it wicking. I would take a puff and then let it sit for a minute before I could use it again or else I'd get dry hits. Other people have reported having good results though so it seems like it could go either way.