Boge Revolution V2 Pre-Orders Now Accepted! 10% off Coupon Code

Status
Not open for further replies.

Jackal3

Unregistered Supplier
ECF Veteran
Jun 22, 2010
893
27
58
Cleveland OH USA
www.whitestagvapor.com
After discussing with Boge, the new Revolution V 2.1 will indeed have a 1400mAh battery. They are also eliminating the "Anion", some sort of negative ionizer they had in the Revolution V2.

I am also ordering extra 10ml bottles, Boge LR 2.0 Ohm cartomizers, and the new Innokin 510-T tank atomizer/tank cartridges for use on the Revolution V2 and V2.1 systems.

I have tested the Innokin 510-T tank atomizer/cartridge... and it puts out almost as much vapor as the Leo-T tank atomizer/cartridge.

The perfect setup will be the Revolution V2.1 w/1400mAh Li-Ion battery and the little Innokin 510-T tank system. It's going to rock your socks off.
 

Jackal3

Unregistered Supplier
ECF Veteran
Jun 22, 2010
893
27
58
Cleveland OH USA
www.whitestagvapor.com
The Revolution v2.1 are HERE!
All pre-orders are officially shipped and at the post office. You should be receiving an email with the tracking number.

Today is the last day for coupon code FATHERSDAY for 10% off my already low priced starter kits, including the Revolution v2.1, all Boge starter kits including the Leo-T starter set, and also the Innokin Lea sets.

Hurry! Coupon ends 12am EST!
 

Jackal3

Unregistered Supplier
ECF Veteran
Jun 22, 2010
893
27
58
Cleveland OH USA
www.whitestagvapor.com
Folks are really feeling the love with the new Revolution v2.1.
The 1400mAh battery lasts me all day, no problems. The standard 510 threaded connection allows me to use any standard 510 cartomizer, clearomizer, atomizer, etc... and they work well!
The bottom fed juicer is top notch. 3-4 squirts and my cartomizer is full again. 1-2 squirts fills an atomizer for dripping.
This is an A+ product, and those who've bought from me will tell you the same.
 

jameth

Super Member
ECF Veteran
Verified Member
Jan 26, 2011
680
638
40
Southern Utah
The standard 510 threaded connection allows me to use any standard 510 cartomizer, clearomizer, atomizer, etc... and they work well!

On the V2.1 have they changed the atty connector at all, or is it the same as the V2 where not all attys/cartos center pin would reach, resulting in no power going to atty unless you pull the center pin out a bit?
 
Status
Not open for further replies.

Users who are viewing this thread