Boge Single Coil Cartomizer XL

[MC28]

Alternatively if u have a dremel and a dot punch, u can just drill a hole like my fren..

 

[Currynoah]

I like the M "DIY Tubecutter With Screw" Carto Puncher! As invented by Madhero!!

Managed to fix it up for less than SGD$5/-

 

[Vinniz]

View attachment 94405

I like the M "DIY Tubecutter With Screw" Carto Puncher! As invented by Madhero!!

Managed to fix it up for less than SGD$5/-

mine still not perfect yet. managed a dent for now..

 

[Currynoah]

Find the sharpest screw you can find.

 

[Heavybag]

Invest in a dremel.Works well on metal.Tried my friend's dremel.Small and powerful!

 

[MC28]

Invest in a dremel.Works well on metal.Tried my friend's dremel.Small and powerful!

And expensive...Not those chiong dremel..

We use those to cut vent holes on our PC case..

 

[Heavybag]

Yeah...Can easily cost zi shi kuai.He use them to drill through alu plates for screws.

 

[snooke_master]

I think more important is the drill bit... My dremel is abt 20 dlr only... but the drill bit set is more than 50 dlrs haha...

 

[Heavybag]

If the material too hard the bit can wear out cui cui.And he got those attactments like the sanding,saw bits.Your hand vibrates and sparks fly.Hand felt so numb afterwards.

 

[fishohunter]

I use saw bit to cut, so far so good...

 

[MC28]

I think more important is the drill bit... My dremel is abt 20 dlr only... but the drill bit set is more than 50 dlrs haha...

"Dremel" from hobbyking going for USD14+..

While my friend authentic Dremel cost him near $200..