Bottom Atomizer RBA's?

[Tintreach]

Excuse my ignorance on these some since I am still a little wet behind the ears. What other rba tanks are out there that have the atomizer on the bottom similar to the kayfun 3? I have been goofing around with Genny style RBA's and looking for something that lets gravity work for you.

 

[JD1]

Check out the thread on the dream 804. Discountvapers has them for 20.99. The 20.99 version doesn't have dream written on the side of the tank for some reason but it's the same as the higher priced one that does have dream on the tank. http://www.e-cigarette-forum.com/fo...ve-new-kayfun-clone-aka-dream-bt804-tank.html

 

[Thyroid]

MISTer-hybrid, similar silica setup than with Kayfun, but also with adjustable juice control like in Odysseus/Penelope. Works excellent with mesh u-wick too. Then there's Spheroid and Taifun atomizers of course.... and Cyclon top feed genesis atomizer.

 

[StaircaseWit]

I want an atty like the MISTer atty. Posts so no NR wire required, and with the juice control I know it would work well with hemp or cotton. Similar designs always use ceramic cups and require NR legs on the coil. Anybody know of one set up like the MISTer?

 

[JD1]

I want an atty like the MISTer atty. Posts so no NR wire required, and with the juice control I know it would work well with hemp or cotton. Similar designs always use ceramic cups and require NR legs on the coil. Anybody know of one set up like the MISTer?

The dream 804 works the same way as the mister and kayfun, but no juice control, no air control, and no fill port at the bottom (like the new kayfun). It's also not leak prof but none of my three leak with normal usage. Their worse fault imo is refilling...something you have to do fairly often because they only take a little over a ml to refill and they fog though that pdq, I can tell you.

If you refill from the top and screw the top back on, then once the threads catch enough to become airtight it'll push juice through the channels as you finish screwing the top on, and flood the atty chamber. So if you fill from the top, the trick is to watch the juice real close and when you start to see some movement, flip it upside down, wait a second for the juice to drain back from the channels, then finish tightening.

I prefer to fill from the bottom, which means I have to plug the mouth piece hole first. I trimmed down the plunger from a small syringe for that. The solid plug to replace your drip tip works as well.

http://www.e-cigarette-forum.com/fo...lone-aka-dream-bt804-tank-17.html#post8855137

http://www.e-cigarette-forum.com/fo...clone-aka-dream-bt804-tank-2.html#post8539200

http://www.e-cigarette-forum.com/fo...clone-aka-dream-bt804-tank-6.html#post8658333

Edit: Also, an SS version is supposed to be on it's way shortly, and I'd also like to add that if you pick one of these up, be prepared to lower your nic content as these really deliver the flavor and nic.

 

[StaircaseWit]

Yeah, I've seen that but was dissuaded by the construction. I'd definitely have to have it in stainless. I'm done with 'mystery metal' devices other than the occasional carto.

I'll keep an eye out for the stainless version. I really want something with that MISTer feed style.