Box mods,

[Simm555]

Hey fellow vapers I am looking for some advice on box mods, I currently use a stingray x for dripping and a vamo v5 for my tanks. I want to invest in a good box mod where I can switch between my drippers and my tanks and still keep good vapour production and taste. I normally drip at 0.2 ohms so the box mod would have to go this low. Thanks in advance folks

 

[Fictitious Character]

Regulated or mech style?

 

[Simm555]

Regulated, been looking at the ivp2

 

[msgnyc]

If your building @ .2ohm I think a dna40 device or even the 50watt box mods may be underpowered for you. At .2ohm your vaping at like 88watts on a fresh battery with a mech. I would say go for one of the 100watt+ box's out there like the God Mod, Sigelei 100watt, ipv3 etc...

More variety in build options.

 

[dice57]

thing is with most the high watt box mods, ideal optimization of mods power lies at 0.4-0.8 ohms. The beauty is can drive that range of build, at a safe amp, and get the same or better vape one experiences with a low, low sub ohm vape, while doing under 20 amps. When pushing under or over that target range, experience big voltage drop and negligible gain in vap potential.

Find optimizing box power constraints no less challenging than optimizing mech/rba restraints. If driving primarily 0.20 ohms or lower, there is no real advantage of going regulated. But, if one wants to experience high watt vaping at a reassembled amp limit, they can be pretty sweet. Can drive a 0.71 ohm build at 100 watts, now that's like cooking with butter, or something like that.!!!!


Vape long and Prosper.!!!

 

[dice57]

Oh, running the Cloupor T6 & T8, also the Sigelei 100 boxes. Find the T6 to be my fave, but big kudos to the T8 and Sigelei too, with slight favoritism to the 8.

 

[Simm555]

Ok guys, thanks for your replys Iv just brought the ipv v2, I have put a 0.8ohm build on it cranked it up to 50w and it vapes like a beast seriously out performs my mech mods with 0.2 builds. Works amazing with my aerotank mega too.. I love this mod, I'll post again in a week or so when iv had time to try out a few more builds

 

[ThunderPack]

I like hana modz. I really want a dna40 mod next though. Someone needs to clone the vapor flask v2 and put a dna40 in it

 

[mdipan116]

Highly suggest an IPV3 or a VaporShark RDNA 30. These 2 are what are always near me and I keep on going back to. High quality and the IPV isn't to costly, but the VaporShark takes that dough.

 

[LMS62]

Ok guys, thanks for your replys Iv just brought the ipv v2, I have put a 0.8ohm build on it cranked it up to 50w and it vapes like a beast seriously out performs my mech mods with 0.2 builds. Works amazing with my aerotank mega too.. I love this mod, I'll post again in a week or so when iv had time to try out a few more builds

I also have an IPV2 and am very happy with it.