build ? hana and tugboat

Status
Not open for further replies.

Double Helix

Senior Member
ECF Veteran
Verified Member
Jun 1, 2014
176
91
Houston, TX
its chucking clouds and great flavor at 10 watts

The thing is that your device only supports a minimum of 4 volts regardless if it's a clone or not. So with that said you're actually using ~26.7 watts. Perhaps you should brush up on ohm's law. I'm not even sure why you'd want to use a device at 2.4 volts even if you could.
 

Hemptation

Ultra Member
ECF Veteran
Verified Member
Jun 18, 2014
1,157
4,977
Ridgeland,MS
Yea. The best build I have found I twisted 28 at 1.4 myself. Running 20-24 watts. Exact set up

And I have to agree. Not sure why you would want to run at 2.4. At .6 tho. It's for to be warm. You are better served running on a straight mech at .6. Just saying And then it's all about your battery

But hey. To each their own. If it floats your tug boat and doesn't blow your hand off you are cool with me. Lol
 

Blackboar

Super Member
ECF Veteran
Verified Member
Mar 17, 2014
467
352
Upper Marlboro, MD
What the others have said. If you want to run less than 0.8 ohms, a mech mod with Sony VTC 4/5's will serve you better. Because at that low a resistance, the Hana is running at its minimum setting anyway, unless you set it above 26 watts.

To take advantage of a regulated mod like a DNA 30, try to build it around 1.3 - 1.5 ohms. You'll get much more out of the mod and the wattage settings will be more accurate, since you'll be able to vape it above the mod's minimum voltage setting.

If you are interested in learning what an optimum build is for any particular device, go to Steam Engine's website (Steam Engine | free vaping calculators) and search for your mod in the mod range section. Try to build a coil at the mod's sweet spot. This is just a little below what would stretch the mod to its maximum voltage and give you a great range to vape on. From there, you can tweak your build up or down depending on your taste. But the sweet spot is a great place to start.
 
Status
Not open for further replies.

Users who are viewing this thread