Button question

Status
Not open for further replies.

leroytwohawks

Super Member
ECF Veteran
Verified Member
David I didn't know if you read this that I posted in another thread so I posted it here.

One thing I was wandering about is with my P10 David sent along a brass button along with my SS one and he says the brass works better with some battery's, I'm assuming it builds up less corrosion from the charge over time so David could you just cut off the steel connection part of the switch and tap in a brass flat screw so we could still have our nice Steel buttons but with better conductivity? Then it would be easy to just sell new brass screws when needed!

Kevin
 

forcedfuel50

Unregistered Supplier
ECF Veteran
At one point i had considered doing what i did with the Precise 18650 and Precise 16340, which is have a replaceable brass contact on the switch, but since i'm having switches done up for the shorter AW batteries, it's not on my immediate to do list, but i may sometime in the future revisit that.
 
Status
Not open for further replies.

Users who are viewing this thread