BuzzPro and Airflow

[nbourbaki]

I have a BuzzPro that I purchased the day the BuzzPro became available. The connector is an 801. I bought this config to use with the IkenVape 801 Fusion cartomizer. The airflow is terrible compared to my other 801 PVs. Is there anything I can do to improve the airflow or is this a warranty issue?

 

[Ruppy]

You need a flathead screw That will fix it right up. You can get them at a hobby store or perhaps you can work out something with Mike. They started including them not long ago.

It hapens because of the indentations on the fusions. It makes the rounded screw head close off the flow.

 

[nbourbaki]

Thanks! So I replace the rounded screw in the connector with a flat head screw. Do you happen to know what the threading is for that screw?

 

[Ruppy]

I dont recall right off but Mike posted it several times. Im sure he will see this and post the sizes

 

[BuzzKill]

m2 size . I have them in stock just email me !

 

[radiated1]

When did you change to flat? Mine looks flat with round sides. Got my buzz 801 cap in sept.

 

[Ruppy]

Its not flat topped its slotted instead of cross. Lets air in from the sides ;

 

[lariders]

I just got my buzzpro but it has a 510 on it. The draw seems really stiff?

 

[Bovinia]

Cartos vary a lot in the thread area. Some you just can't screw down tight and get airflow. I get one every now and then that I have to leave a little loose. Or you could try the slotted screw Mike (Buzzkill) suggests.