BVC Rebuild & Shorts

[AJR091458]

I'm trying to rebuild nautilus mini BVC's and am doing something wrong. I watched Rip Trippers video but after what looks like a good rebuild and reassemble, my eleaf says 0.2 ohms or Atomizer low. Any idea where my mistake is? (Besides trying to rebuild these dopey little things.)

 

[Sir2fyablyNutz]

Those are fun to rebuild. I use the steam engine to figure out the wraps, wire size etc... Coil wrapping | Steam Engine | free vaping calculators I am only guessing but you may have built to a resistance too low for the istick to read.

 

[Marmaduke]

Or the wire may be touching the walls of the chamber?

 

[AJR091458]

I did 11 times around. Should read higher than 0.2. I was thinking the same thing, a short to the chamber wall. Is there a way around this or is it just a matter of practice? You really can't see if the wire is touching for all the cotton.

 

[Sir2fyablyNutz]

Practice. I am usually successful 2 out of three times. It does get easier.

 

[AJR091458]

Thanks everyone. It's tedious but I figger if I can build rigged clipper ship models that this is a lesser level of difficulty. Probably good therapy too! (Nyuk, Nyuk, Nyuk.)