can anyone give me help on a phoenix rebuildable atomizer?

[ogpanda]

so i have a volcano lavatube v2..i am wondering how my phoenix rebuildable atty will work on it, if anyone can help me on this it would be very helpful n at the moment i have a vamo with a DID atty on it and it works fine, i just really wanna make sure it is truly compatable with a lavatube v2

 

[ogpanda]

i just need a double check on how to hitt the right ohm's on the phoenix atty, alto i already know how to use a mesh on my DID, i just dont know how to build with the wick n wire yet

 

[RelativeBewt]

check out youtube, theres a tut for everything now

 

[ogpanda]

most of the stuf i seen on youtube is with the older lavatubes not the v2 w/ rebuildable i could not find any

 

[RelativeBewt]

how you will hit the target res is going to differ depending on wire size and a million other variables. as for the lavatube, it uses the "33.3 chipset" as PBusardo describes it. so im sure itll work about like the vamo or any other vv mod

 

[ogpanda]

i see, yup so instead of ordering mesh, i got sillica and kenthal 30g..ill try it out tomorrow.

 

[ogpanda]

whut is the ohm cutt off for the lavatube v2?

 

[RelativeBewt]

GrimmGreens vid on the phoenix -> MY GO AROUND WITH THE PHOENIX REBUILDABLE ATOMIZER - YouTube
PBusardos vid on phoenix -> A PBusardo Review - The Bulldog Rebuildable Atomizer - YouTube
and on lavatube v2 -> A PBusardo Review - LAVATUBE Version 2 - YouTube

 

[RelativeBewt]

pretty certain its 1.3 ohms

 

[ogpanda]

thanks alot mate :0

 

[RelativeBewt]

no problem