Can U Help? What is this?

[MonicaRae]

I got these cheap clearos off Ebay. Not these but top coils & they were horrible (lived & learned) so the guy was pretty cool. Contacted him let him know all 10 tasted like plastic and he sent me some of these bottom coil clearos.

Anyway anyone know what these are or what they are "like" I wanna look up on YouTube how to rebuild the coil. I see all kind of protank rebuild videos and stuff but the coil just seems so much bigger.

I haven't ripped one apart so I don't know if its dual coil or single but I can't imagine that its a dual!
Thanks

 

[LazyBulldogge]

No idea what the clearo on the picture is called, but the coil looks like it can be rebuilt the same way you rebuild a Protank coil, just a bit shorter air tube, so might be bit harder to wiggle it out from the base of the coil.

Edit: Might be a Kanger T3S or a clone of a T3S - kinda looks that way on further inspection, but I'm not sure.

 

[DavidOck]

I think Lazy's right, a T3S clone. Rebuild will be the same as that, or Evod, or PT.

 

[MonicaRae]

Thank you Thank you!!

Guess we'll just have to see. Oh & def learned my lesson with cheap stuff on Ebay even though these are not too bad just a bit airy.

 

[Hulamoon]

You should have 3? airholes in the base, just plug one with a piece of toothpick..

 

[Dampmaskin]

Reminds me of the GS-H2 clearos I used before i went all Kanger. Two airholes in the base?

I have successfully rebuilt the GS-H2. The atomizer is very much like the PT head, only a little bit smaller. You can even use PT heads in the GS-H2, although it takes a little bit of coercion.

 

[MonicaRae]

Ya I just checked it has 2 airholes in the base opposite each other.

I reread my first post & I think it may have been confusing but the heads on these are tiny or they seem tiny to me. I had a T3 & the head on that was much bigger these.

Not sure if I should even bother trying to rebuild them but I figure why not? I spent $14 on junk just trying to make them reasonable!

 

[Dampmaskin]

Yes, the chimney/top hat is tiny compared to the Kangers. The rest of the atomizer is only slightly smaller, and you can actually put a Kanger chimney on the GS-H2 atty, and vice versa. It's not a perfect fit, but good enough in a pinch.

 

[Huckleberried]

Leave the head on the base, use needle nose pliers to wiggle the chimney back and forth. Should help a little. At least it'll give you a bit more to hold onto.