Hello, I am new to this site, but have been looking at it for a long time. I have an Electronic cigarette, 1 of those cheapy 20$ ones and I refill the cartomizers. After a little while, they stop absorbing the eliquid and only get like 2 drops in. I tried a version of boiling but that left no vapor or flavor when i refilled it(but it did refill). I know its not full when it stops absorbing because I start to get a different taste and vapor goes down. I have been struggling with this problem for a while and would really love some help.
Cartomizer not absorbing?
- Thread starter Twistedblud
- Start date
- th_trl_thread_readers 0
- Status
Use thin juices (high PG). I use 80PG/20VG
Use light clear juices. Dark, cloudy or opaque juices often drop flavoring sediment that clogs cartos and turns the stuffing into a solid pudding-like mess
Cartomizers are disposable. I can get 7-10 days of use out cartomizer or about 20ml run through it. Then I fill and settle a fresh one and throw out the old one.
Use light clear juices. Dark, cloudy or opaque juices often drop flavoring sediment that clogs cartos and turns the stuffing into a solid pudding-like mess
Cartomizers are disposable. I can get 7-10 days of use out cartomizer or about 20ml run through it. Then I fill and settle a fresh one and throw out the old one.
...best I can tell ya is to go get something legit...if you get a week out of a carto, you have done well.......
madjack
madjack
if you're getting no vapor at all after boiling and refilling, it could be that there is still water in them...blow out the excess water right after cooling them, and then let them dry *thoroughly*...i'd set them aside for 48 hours before filling them.
It sounds like it's just not a very good system, unfortunately. I'm using an Ego battery with Boge 510 LR cartomizers. I've had really good results with that.
I would suggest as well a better kit may also be more satisfying. It just sounds like you may be using a "cigarette look-alike" I think you would have more luck using something like a Boge if you can find a pack in your threading. The most common is 510.
Thank you for all of your advice. I just recently ordered the 510-t ecig and in wait for it now. I have found a solution to my problem by removing the filament of the cartomizer and direct dripping onto the atty inside it. Turns out the inLife Regal ecig cartomizers have a bottom coil atty inside so i was able to remove all of the burnable material. I am now looking for a way to turn the cartomizer into a tank or possible mod it into a 3 piece ecig for my own amusement 
- Status
Similar threads
