Title says it all. A cart that has a small air channel on the inside. The straw mod revolutionized my vaping experience. Topping off is easier, wicking is far better, no liquid gets popped out of the cart (and into your mouth) by expanding air pockets, and the carts drag completely dry.
Title says it all. A cart that has a small air channel on the inside. The straw mod revolutionized my vaping experience. Topping off is easier, wicking is far better, no liquid gets popped out of the cart (and into your mouth) by expanding air pockets, and the carts drag completely dry.
I don't see any model numbers listed in these posts. Are you looking for a round 510 cart, approx the same length, with double the juice capacity and a built-in vent tube? What other models?
I don't see any model numbers listed in these posts. Are you looking for a round 510 cart, approx the same length, with double the juice capacity and a built-in vent tube? What other models?
I'd say that the easiest way of doing it would be to have a mouthpiece with an internal chamber for the cart, to suspend the chamber you would create channels that would act as the straw. whether to perforate the bottom of the internal chamber to create some airflow back through the filler (for flavour) or to leave it solid to create maximum suction of liquid up through the wick would probably have to be tested.
Apologies if this isn't what others had in mind, it is however what I'd like to see. And particularly for the 901.
I'd say that the easiest way of doing it would be to have a mouthpiece with an internal chamber for the cart, to suspend the chamber you would create channels that would act as the straw. whether to perforate the bottom of the internal chamber to create some airflow back through the filler (for flavour) or to leave it solid to create maximum suction of liquid up through the wick would probably have to be tested.
Apologies if this isn't what others had in mind, it is however what I'd like to see. And particularly for the 901.
similar to the 401 carts, kinda. but i have one kind of 401 cart that really "sucks" had just puts juice in the mouth piece, and i have another that works pretty much like a charm. but they still dont have an actual air release where the filler is. so the chambers would still have to be where the filler is..... ugh, i dont think i made sense...
and those are the primary air holes on that type of cart. you could with some hot glue and and a hot needle, block the mouth opening, and open the bottom inside to the resevour<sp> on that type of single piece cart (their are a few 901 cart types, the two piece, the d-shaped inner res.) have not see them for a while (well since may.)
that one came with one (and only one!) of the first kits i got from TW, since then have had two diferent types from three different suppliers, i use that cart till i bit it and split it in two then a few weeks later saw the straw mod too late.
"and those are the primary air holes on that type of cart."
ohhhh... I didn't realize those were the air holes! LOL.. silly me.
I think you're right, they could easily be modified. I guess they don't make these any more. ??
i have not seen them again, but again, i got a few of the d-shaped and two piece(over 100, blank) on hand and have not got any new ones for 1 1/2 months...
the old if i knew then what i know now thing, at work, up close and personal. hehehe
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.