Anyone using the CCell coils in a Triton 2? I put a Ni200 one in my Triton 2 and it was reading ohms but wouldn't fire. I took it out, put the stock coil in and vaped it for a day and then tried Ni200 again and it worked. Just wondering if anyone else is using this combo. coils are Triton compatible so I'd think they'd be ok. Also I have the kanthal one in my Playboy Vixen tank and looove this coil. Just want to know how many more to order.
- Status
Can't speak for the Triton 2, but I did have one for my Atlantis 2. Honestly, hated it. Too much air restriction for me. But a good concept. I got the Freemax Scylla which has a .3 ohm ceramic coil and it rocks. I love it. But best of luck with the ccell coils
I've used the CCell in the Triton1 without issue. It's probably a contact issue between the mod, pin, atty, coil somewhere. I find I have best results (with most any tank/coil) by screwing the atty deck in to the mod, then screwing the coil down until the mod reads it and it is snug. I have had non-firing issues if I screw the coil into the deck first and the combo into the mod. Usually coil-short due to bending the pin too far.
Going on a month with the cCell Ceramics .3 & .9 in Triton 1's, Atlantis 1 & 2's & Atlantis Mega's with Zero issues! I like em Best in the Atlantis Mega Tanks!
Skully {:{}
Skully {:{}
I have the .9 ohm kanthal ones in both my Triton 1 and Triton 2. Love them! I'm going on two weeks with the same coils, and the flavour is still spectacular. No misfiring issues for me, but I did notice that you have to use juices that are at least 65/35 vg/pg. I was getting burnt hits like crazy trying to use a 50/50 vg/pg juice. Not an issue for me, since I usually user higher vg juices anyway.
They do fit in the Triton 2, but I am having problems with the CCELL Ni200 in TC mode, No Flavor, could be and probably is because I am a NOOB? But they do fit!
- Status
Similar threads
