Changing e Juice in Kanger T3s

Status
Not open for further replies.

BlueMoods

Ultra Member
ECF Veteran
Verified Member
Aug 19, 2010
1,654
1,395
USA - Arkansas
First, I am going to assume you use a blunt tipped needle bottle or syringe to fill it, if not you will need one or the other - empty. Use the bottle or syringe to pull as much juice as you can out of it, remove the tip, rinse 2-3 times with as hot a water as your hands can take, shake out as much water as you can, let air dry for one hour, then dry burn it. Do not put the tip on, attach the battery, activate it for 2-3 seconds, pause for 5 seconds, repeat until you can look down it and see the coils glow orange and, no or very little vapor or smoke comes out of it. Fill with desired juice, put tip on, vape away.
 

iceman68

Super Member
ECF Veteran
Verified Member
Apr 24, 2013
406
281
Chicago, IL, USA
The T3S is a bottom coil clearo and the base will unscrew from the tank. Turn it upside down before unscrewing the base or else the liquid will just run out all over. Once the base is off you can just dump out the old liquid or save it if you prefer by pouring it into a bottle.

Then you can rinse out the tank with water, rinse the base and coil, and pat dry with paper towel. You can let everything air dry for a while if you choose or just refill and go. I do it with my EVOD which is similar. Just refill the tank (don't fill over the top of center tube), screw the base and coil on, and wait a bit for the wicks to soak up the liquid. The first few pulls may have little or no vapor but just give it time for the wicks to become saturated and then all should be well.
 
Status
Not open for further replies.

Users who are viewing this thread