Changing juices. What else should I change?

[JonasDK]

Hey guys.

So I'm just about to mix a new batch of juice. And this time, instead of a high pg juice, I wanted to try a high vg juice. But I'm not sure of what I should use to make it thinner. Or if that's even necessary.
I'm going to be vaping it on a Goblin and a mutation X. So I was thinking that it would be sufficient to just thin out the wicks a little. Or am I way of?

 

[Susan~S]

Make of small batch of of high VG juice. Try it with your setup. If it doesn't wick well, add a few drops of distilled water (per ml of juice) and vape it again.

 

[Verb]

Should be fine. You might have to play with coil diameter and wick density if you get dry hits.

 

[Bunnykiller]

I make and use 100VG juices... no problems here..

 

[NancyR]

I also use high vg, without problems.

If you are adding any flavors, they are most likely pg based. Depending on the % of flavor used you will have about a 20/80 pg/vg ratio when finished. I personally do not like adding water even just a few drops as in 901's or 306's you can really notice the water in the last hit or two. It is not a good taste or a good vape.

 

[Light Seeker]

Most my juices are either 50/50 or 95+vg. I've found I needed to increase my coil diameter from 2mm to 2.75 or higher to add more wicking and prevent dry hits with high vg. And I totally agree with Nancy above, dilluting with water tastes bad!

 

[TXBiker]

I use nothing but max vg my coils stay at 3mm I.d. Wicking was a small challenge in my orchid. I kept over doing it. I would back off the chimney 2 turns for more flow and still get that wet t shirt taste, with great vapor though. Now I cut a strip of KGD to length and split it in half, there's the slightest drag on the wicks going in and it works great. My dripper isn't as picky I wick it just slightly tighter than my rta tuck the tails and go to town. The only juice I have that's thinner than my atf locally made, is my boba's and I have to wick tighter for it or I get a tiny leak.

 

[Alien Traveler]

I sometimes use VG with 10-15% of water. Works fine. Almost no flavors (not more than 2%), so almost no PG from them.