Changing tanks and flavors

[Marc411]

Swapping bottle is pretty easy, I unscrewed the bottle left the end in put my finger over the air hole and blew most of what was in the tube back into the bottle. Wiped the outside of the tube off and everything is almost ready.

I am going from the Virus to a custard and there is still juice in the tube.

Don't worry about it, it will work it's way out.

Or is there something better.

I tried using the advance search but not matter what I tried I didn't get the results I was looking for, sorry if this has been asked 1000 times.

 

[Filthy-Beast]

Yep that's about it, you might want to change the wick if using something like cotton. I typically vape complimentary flavors so the overlap doesn't bother me and I run ceramic wicks so I can dry burn them clean if they flavors don't blend well.

 

[patrao_n]

Thats the way I do it. A few puffs might be a little weird. But after that it fixed itself

Sent from my SM-N900T

 

[solace.discord]

pretty much how it's done- that might be a very pleasant mix..

other option is to remove the bottle and wick and run under warm water, through the tube to really clear it out.. blow out, dry off, re-wick, load it up and go.

 

[Bigflyrodder]

Oh, I didn't know you could change flavors. I just keep buying more Reos.

 

[AmandaD]

Oh, I didn't know you could change flavors. I just keep buying more Reos.

Exactly!

 

[Ian444]

Some people change the bottle with the feed tube still connected to the bottle, and slip in a new feed tube/bottle combo to change flavors.

Some say a lot of flavor gets trapped in the o-ring in the bottle cap, which adds weight to the above, or just change the o-ring if its a one-time flavor change and you can't get rid of the old one.

Another idea is you turn the mod nearly upside down and run the atty under the tap (with the cap off), then fit a new wick or dry burn the existing wick if its silica or ceramic. This washes away most remaining juice, I do this whenever I rewick to save removing the atty for a wash.

To go one step further, remove the atty and totally rinse it under tap water, or fill a bottle with water, connect it to the feed tube and squeeze the bottle to flush the water right through the 510 connection and atty. Hold the mod near upside-down so the water doesn't go all over it.

 

[Marc411]

Ian, great idea to put water in a bottle to flush the system. I run the same program cleaning the RDA and that last piece just closed the gap.

I appeciate everyone's assistance.

 

[SLIPPY_EEL]

it doesnt happen very often cus my flavours pretty much blend together pretty well but if i need to clean the inside of the rba and tube quickly, while the waters running i'll take a mouth full of water and force it either up the tube or down through the rba while holding the tube out towards the sink

just make sure you dont blow down through the rba if you've just fired the coil ..it hurts




a few times ive cleaned the tube and bottle with bicarbonate and white vin but it doesnt taste nice so then you rinse in vodka after dont like that either.. so i dont clean it now