Changing the juice in an iclear30 cartomizer

[gfht]

I got an iclear30 cartomizer. I only bought one that I've been using to vape and I got some new juice in the mail.
Seeing I'm still relatively new to this. Can anyone tell me the procedure to wash or prep the cartomizer so that it can be filled with a new flavor

Thanks in advance

 

[Talyon]

U can rinse under warm water till wicks are whitish again than let dry real good. Once done dry burn by pulsing trigger about 4-6 times and fill er up. For a more thorough cleaning use Vodka, but warm water does the trick. Enjoy.

 

[nicetucu]

Yeah I agree with Talyon.... I just rinse it with hot tap water and then stick mine in a coffee cup with hot water from a water cooler we have at home and drain water and fill a few times (once the water cools off). When the water smells less like the previous juice I'm good to go. Be careful not to lose the small parts like the rubber cap and take the whole thing apart. The iclear30 has two coils and no flavor wicks. I just dry the parts off as best you can with paper towel and dry burn it.

I don't really let it dry that long before I dry burn it , but probably would be better if I did. Just assemble the post on the connection and put it on the battery (so you can look at the coils , no rubber cap , bare). I turn my voltage to 4.8 (on my ego twist) and power on the battery more like 3 to 4 seconds at a time and blow a bit on the coil to cool it off. Once the coil gets hot it will burn most of the residue of the old juice. Don't let it burn more than a couple to three seconds. You'll notice the wick turns white after a few minutes and blow on it and I'm good to go at that point. Some people soak it again and let it dry overnight.