Cheap way to power a Kangertech Aerotank Turbo?

[Marduk]

Hello all,

basically, I would like to know of a good power source for my Turbo. I was recently sold an eleaf istick by my local B&M. The same store sold me a Kangertech Aerotank Turbo after a fellow customer sold me on it. (He was using this same combo.) Little did I know, the istick won't fire below 1 ohm. Now, I would like to know a decent solution to getting my Turbo working.

Will an iTaste MVP 2 fire an Aerotank Turbo? The only other option (buying from my local B&M) would be to step into the land of mech mods. They hooked me up on one of their mech mod clones with a 30 amp 18650 and then a 10 amp 18650 after the previous was too harsh. So, after reading a little about mech mods and the Turbo, I need to use at least 30 amps? Does anyone have any insight into this?

All in all, I'd like to know I which is the best route to go.

 

[ntoine101]

The MVP will not fire under 1.2 ohm, I would get at least a 30 watt device, like something from either focalecig or fasttech, and put a good 18650 in there, or get a mech mod OR get coils over 1 ohm lol [emoji12]

 

[Skunk!]

I would probably go with a 26650 mech mod for that tank. You could find one that is the same diameter and would look seamless with it. The dual-dual coil setup and sub ohms would be perfect for a mechanical. They are a bit heavier, but I have to carry extra batteries for my 18650 so it kinda evens out.