Choosing batteries for Wismec Reuleaux RX200

Status
Not open for further replies.

JimZet

Super Member
ECF Veteran
Verified Member
Dec 31, 2015
319
358
35
Hello,
Title kinda talks for itself,
I've ordered Wismec Reuleaux RX200, and have no idea what batteries to buy, i plan on vaping on 50W-140W.
After reading a lot about safety, i did not understand tables at all, all i want is good safe as possible rechargeable 18650 batteries.
Also if charger plays any role in safety than recommend some charger.
Could you suggest some please?
 

zeus01

Super Member
ECF Veteran
Aug 19, 2011
403
397
39
manila
lg h2 (3000mah,20a)
lg he2 batts (2500mah,30a(if i recall right)
samsung 25r

all three would serve your mod well,

chargers just buy any those intelligent charges,by xstar or nitecore

just make sure you charge all 3 batteries and use all 3 batteries,exclusive to the mod alon.

other than that your fine,

its variable device afterall,should take care most of your worries opn batteryu safety
just make sure to periodically
check all the batts for any signs of peeling ,scratches or any form of metal being exposed on the batts
and do change the batteries position on the mod from time to time
 

Ablonz

Ultra Member
ECF Veteran
Sep 17, 2014
1,616
2,514
Frozen Tundra, WI Cheesehead
I personally would go with the VCT 4s or the Samsung 25R from a reputable battery company. You can get them here: Batteries - Batteries, Chargers, and PowerPax Carriers The charger that I have and works really good IMO would be the Nitecore D4 found here: Nitecore D4 Digicharger Li-ion, NiMH/NiCd Charger - Chargers - Batteries, Chargers, and PowerPax Carriers Also to what was posted above for marrying the batteries to the mod and rotate them each charge. Label them 1,2,3 or something like that and alternate them. Say 123 as your looking at the mod, then next time you replace them back in put them in 312 order, then 231 ect. That will help them keep draining at the same rate sorta like rotating tires on a vehicle. Hope this helps.
 
Status
Not open for further replies.

Users who are viewing this thread