Cisco 2.0 and VV

[squirrel64]

I posted this question in (ask the veterans) forum but it said it had to be reviewed. So the next morning I got up and it still was not posted. Sorry about the double post.


I was wondering if anyone has used the newer Cisco 2.0 atties with their variable voltage units and what voltage are you finding best with these. I was going to make a small order tonight and that was why I'm kind of in a hurry for any input.

 

[warbdan]

Well, there is no right answer here. If you used them at around 3.7v to 4 -ish volts they would probably be fine. If you go too high in voltage they will most likely pop. At only 5 volts a 2.0 ohm atty would be nearing 13 watts which could surely fry it.

****Please vape Responsibly!****

 

[nickf41680]

i use a 1.5 ohm cisco and vape at 3.7v round 9 watts with a 2.0 ohm i wouldnt go past 4.3 ishh

 

[squirrel64]

I had read so many good reviews on the 1.5. Just ordered the 2.0 and wondering how people like it. Thanks