I love the Cisco 1.5ohm 306 atties. I am using a vv device and was wondering if the Cisco 2.0 ohm atties would last longer than the 1.5 ohms at the same wattage?
Life of Cisco 2.0 ohm 306 atty vs 1.5 ohm
- Thread starter jmanning
- Start date
- th_trl_thread_readers 0
- Status
See my sig...Im a Cisco fanboy but with a VV dont you take the chance of accidently cranking up the voltage. My REO last over 3 months with 2 LR306s 1.5Ω in rotation.
I suppose you could, but I never adjust the voltage without my volt meter and keep the voltage to 4.2 or below for LR atties. It takes a screwdriver to adjust the voltage on my device.
Last edited:
- Status
Similar threads
