Cisco 510 1.5ohm atty on 1000mah joye ego-c twist?

[ashechtman]

Hey everyone, i bought my first PV a few weeks ago and i went with the 1000mah Joye ego-c twist. At first i was using boge LR cartos but i want to try dripping so i purchased 2 cisco spec 510 LR 1.5ohm atomizers. I was wondering if i can use these powerful attys on my 1000mah joye ego twist. If so, what voltage should i use? (i like warm, thick vapor and reckless TH). Can my ego twist handle the cisco 1.5s? Please feel free to get technical with the ohms, voltages, watts, amps, etc... I'd like to get a provari but i just can't afford one at the moment so i hope my ego will suffice.

Thanks in advance!

 

[billo]

I've always used 1.8 ohms on my Twist, and 1.5 should work as well.

You have to remember that the Twist limits the current at about 2.5 amps, so the maximum voltage is 2.5*1.5= 3.75 Volts.
Setting the voltage higher will do no good since the voltage will stop going up at about 3.75 volts.

You actually get the most power around 1.9 ohms because of the current limit and 4.8 V voltage limit, but the difference is minor.

 

[ashechtman]

Awesome, so 3.7 volt max with the 1.5 ohm attys. Do you think they'll drain the battery considerably faster than the boge lr 2.0 cartos?