Cleaning my mini

[Burnsie]

Since I got my mini it seems it is always with me, in my pocket, on the end table while I'm watching tube, were ever, but mostly in my hand. Now I will wipe down the outside with a damp soft cloth. The inside is a little harder to do around the battery spring ect. Can I take the bottle out , the battery and atty off and rinse the whole device in soapy water and rinse it or is this not recommend.

 

[Rhapsodies Fire]

You can rinse the whole mod (minus battery, atty, and juice bottle) using very hot water. I don't think there is a need for soap as it can leave a residue. If you are concerned about germs or whatever, you can rinse it in alcohol and do spot cleaning with a qtip + alcohol. 99% Iso-Propyl does well and doesn't leave residue behind. Just make sure that it is dry when you re-assemble for use. Compressed air works great in getting excess water out.

 

[581775017]

I just did that, and yes hot water is enough... inside should be pretty clean anyways.. I gave it a good clean because it started acting werid... Everytime i squeeze to get juice up it use to be perfect! I would see the juice peek out and i would stop! But recently it started getting bubblely, everytime i squeeze it would make a bubble and juice will get all over my well area! But the atty wouldn't be wet yet! Just a mess overall... If anyone know what is causing this problem please let me know! After cleaning it got better but still doing it once in a while..

 

[Rhapsodies Fire]

I just did that, and yes hot water is enough... inside should be pretty clean anyways.. I gave it a good clean because it started acting werid... Everytime i squeeze to get juice up it use to be perfect! I would see the juice peek out and i would stop! But recently it started getting bubblely, everytime i squeeze it would make a bubble and juice will get all over my well area! But the atty wouldn't be wet yet! Just a mess overall... If anyone know what is causing this problem please let me know! After cleaning it got better but still doing it once in a while..

Check that your o-ring is seated properly in the cap. If the cap is on too tightly it can squeeze the o-ring out of place. However...I did notice that this did occur with my LR510s. Right now I'm using LR306s and my wells are dry most of the time.

 

[Big Hitter]

I just did that, and yes hot water is enough... inside should be pretty clean anyways.. I gave it a good clean because it started acting werid... Everytime i squeeze to get juice up it use to be perfect! I would see the juice peek out and i would stop! But recently it started getting bubblely, everytime i squeeze it would make a bubble and juice will get all over my well area! But the atty wouldn't be wet yet! Just a mess overall... If anyone know what is causing this problem please let me know! After cleaning it got better but still doing it once in a while..

the bubbling happens more when the juice is warm IMO

Vaping in the winter works so much better.

 

[mlinky]

Also make sure that the end of your feeding tube isn't pressed flat against the wall or bottom of your bottle.

 

[581775017]

Check that your o-ring is seated properly in the cap. If the cap is on too tightly it can squeeze the o-ring out of place. However...I did notice that this did occur with my LR510s. Right now I'm using LR306s and my wells are dry most of the time.

I check and the O ring is at the top and hasn't moved since day 1. I think some how air is getting in therefore bubbles are being produced. Idk but when i washed it, I used a empty bottle and squirt very hot water through the tubing seem to help a bit... I am using a LR510 though if that makes a diffrence. If anyone else got a answer for this let me know! Thanks