Cleaning overfilled 510 carto threads?

Status
Not open for further replies.

spaceballsrules

Ultra Member
ECF Veteran
Verified Member
Dec 6, 2011
2,858
3,261
North Carolina, USA
Hope you guys can help me on this. I was filling my 510 carto with some Boba's. I stick on the condom, and proceed to drip and taryn spin til full, but the condom didn't plug the hole completely, so some juice that got into the center wick tube got through the plug. So I am trying to clean off the threads and connector, but there is a recessed ring between the two I just can't get into with paper towels or cotton swabs. Any advice?

Here is a pic for to demonstrate what I am talking about. The circle on the far left is a literally a pool of juice, and the rest are just spots on the walls of the "cavern."

P1150438.jpg
 
Last edited:

spaceballsrules

Ultra Member
ECF Veteran
Verified Member
Dec 6, 2011
2,858
3,261
North Carolina, USA
I just wash my cartos with hot water. Just load the syringe with some hot water and with the needle on, squish the water in the screw end of the carto. That usually works too.

That would work with an empty carto, but I am trying to clean it AND preserve the juice in it, as this is post refill. Thanks anyway. :)
 
Status
Not open for further replies.

Users who are viewing this thread