Clearo question

Status
Not open for further replies.

zoiDman

My -0^10 = Nothing at All*
Supporting Member
ECF Veteran
Apr 16, 2010
41,611
1
84,696
So-Cal
Very cool that you have gotten so many miles out of your Clearo's.

The arn't too many good substitutes for the cup seal. With the possible exception to something like this...



Do you have an extra mouth piece or two laying around?
 

Nomoreash

Vaping Master
ECF Veteran
Verified Member
Aug 9, 2010
3,261
931
Chattanooga, TN
I don't know a good replacement but I'm going on 4 months with mine and no breakdown of the cup seal. If you're using a solution to clean them it might be breaking the silicone down over time. Try just rinsing the seal with water, if you're careful pulling them out and putting them back in they should last.
 

res125

Ultra Member
ECF Veteran
Verified Member
Dec 10, 2010
1,686
1,384
PA
Just curious. How do you do your weekly cleaning?
I get pretty long life from my Clearo's but it sounds like you have a good tech for making them last.




I just take the tip and silicone seal that's around the cup off. I fill the clearo with hot water from the faucet and then shake out. I'll do this until everything is clean and the wick is white. After they dry out I do a dry burn to get all the gunk off the coil.

I do this every weekend and have had good luck keeping them running without leaks. The only problem so far has been the silicone seal that goes around the cup - it starting to break apart from taking it in and out so many times.
 

DMF

Super Member
ECF Veteran
Nov 27, 2010
765
240
Slower Lower Delaware
Stretch em as long as you can, the newer version(past two months) has a weaker coil and the wick isn't as sturdy as the first r5 ver was. I usually get a couple months out of a box but this last shipment , I've been averaging a couple weeks maximum and that's stretching it considerably. I also clean mine regularly, though I take the tube off and rinse. Those tubes that break get syringe modded.
 
Status
Not open for further replies.

Users who are viewing this thread