Clearomizer disappointment

[Josephmbk]

Got the ego C type B and the tanks do leak a bit. So I just got in some clearomizers from valuevapors.com and wow they are really bad. No vapor (hardly) hard to draw on, flavor is not there as it was with the tanks. Did get a bad batch or do something wrong because these are not performing anything like the videos I have seen. Anyone else experience this? Feels like I got burned!

 

[Cyrus Vap]

Can't comment on the ego C as I've never used it, I'm sure others will be here soon for rescue I hear its a great unit, maybe it needs a tweak

What clearos did you get from value vapor?

 

[skelley]

What type of clearomizers did you get?

 

[Josephmbk]

Low resistance stardust ones

 

[skelley]

Dang CV...your're fast....lol.

 

[Cyrus Vap]

Its the only thread in the new members forum I'll touch. Not going to negotiate a sea of "buy an eGo its the best"

 

[Vapoor eyes er]

Looks like they'r selling the shorter wick V1. The new V2 have the longer wick. Try rolling the clearo on it's side to wet the wick more. Every so often you will have to tilt and wet the wick. I've got a couple and they're fine except for the short wick but also have the V2- much improved.

 

[Cyrus Vap]

OK so stardust

They do have a hard draw, but if you're not getting much vapor, we shouldn't go there yet

What PV are you using?

 

[Josephmbk]

using just a ego C 1000mah batt. Have had em upside down, let them soak a bit, still nothing good.

 

[Cyrus Vap]

are you getting burnt hits? or just weak vapor? is your battery fully charged?

 

[Josephmbk]

I have tried diffferent juices, no change. I slap on my type B tank and it's like ahhhh..... so much better. Something has got to be wrong here.

 

[Josephmbk]

yeah battery is good, no burnt taste, just hard hard draws and maybe one-third of the vapor I get from the default tanks

 

[Cyrus Vap]

I say you get your post count up, and then come here

http://www.e-cigarette-forum.com/forum/kr808d-1/270854-clearomizer-round-up-808s.html

 

[Vapoor eyes er]

An eGo 1000 should be fine. A friend use that on his V1 Stardusts.
Try this. Remove from PV. Draw on it. Is it an ok draw? If it's an ok draw then get some needle nosed pliers or tweezers and pull the airway at the batt end GENTLY out about 1/ 64".

 

[r77r7r]

http://www.e-cigarette-forum.com/forum/cartomizers/299876-cartos-vs-stardust-2.html

 

[Cyrus Vap]

I'm wiling to bet your coil is flooded. Try blowing really hard from the base of the stardust UPwards, see if crap comes flying out

 

[Josephmbk]

An eGo 1000 should be fine. A friend use that on his V1 Stardusts.
Try this. Remove from PV. Draw on it. Is it an ok draw? If it's an ok draw then get some needle nosed pliers or tweezers and pull the airway at the batt end GENTLY out about 1/ 64".

yeah the draw is ok when not attached to the PV I will give that a try

 

[Cyrus Vap]

Just my two cents, I would absolutely not adjust your battery just yet

Please check and see if you're flooded before you even think about that

 

[Josephmbk]

I'm wiling to bet your coil is flooded. Try blowing really hard from the base of the stardust UPwards, see if crap comes flying out

tried that, nothing. but when I blew Down juice came out a bit

 

[Vapoor eyes er]

I didn't suggest adjusting/touching the batt but the air way tube at the batt end of the clearomizer. Have had to do this for friends that own the V1 and had tight draw. Done it on maybe for 25 clearos so I believe the problem is widespread/ common among the V1s.

Just my two cents, I would absolutely not adjust your battery just yet

Please check and see if you're flooded before you even think about that