[CLOSED]

Status
Not open for further replies.

dolphins35

Vaping Master
ECF Veteran
Verified Member
Oct 22, 2012
8,705
9,042
Spanaway, Wa
Hi everyone.
I have been super busy this last week.
I hope you all are having a great Monday!

I have been having to lay off on Bryan's juices for a few days. I think I vaped my vanilla tastebuds senseless, LMAO!
Everything tastes the same and just makes me mad.

I switched over to some Dragonfruit and Ecto Cooler this week to give my tastebuds a chance to realize the are missing that flan, custard and cannoli :)

Does anyone else ever have this problem??
 

ColoradoVapz

Senior Member
ECF Veteran
Verified Member
Feb 10, 2014
265
389
Denver, CO
The positive contact inside my Provari gets tarnished over time and I clean it up here and there. Seems to add power to it. Usually I can look inside and see that it's discolored and needs a cleaning. I usually just put a small bit of brass polish on a q tip and spin it around on the contact until it's shiny again.
 

Waho

Ultra Member
ECF Veteran
Verified Member
Jul 22, 2010
2,276
3,102
38
Michigan
When my Mom's provari started acting up (a fresh 4.2v battery was reading 3.7v and would work for ~10 pulls before flashing and quitting) I put about an inch of water/soap in the ultrasonic cleaner and stood the provari upright with the cap next to it to give the threads a good clean. They were full of purse lint and whatnot and it brought it right back to life.

Second what Colorado said! That contact inside gets tarnished and a good swab with a qtip and polish works great.
 

Cob24

Ultra Member
ECF Veteran
Verified Member
Nov 18, 2013
2,149
5,277
A place some call paradise
That discussion is always in motion. I sold mine so I'm not as involved with it as I used to be but from what I've heard they're going to continue to make the 2.5 when they make the v3. I'm not sure if it's speculation or not just what I've heard

If they made something that could handle subohm the same way it handles 2 ohms I'd be back on board though
 
Status
Not open for further replies.

Users who are viewing this thread