cloud chasing.

[Ryan Kelly]

so i know many of you guys don't like/are against cloud chasing so if you are then feel free to not read this post haha.

I'm starting to get into cloud chasing a lot. i was just wondering what things i could do to make my clouds bigger. i know the basics. i usually run a dual micro coil setup at about .3 ohms in my omega RDA with 3 mm air holes. i use max VG juice bust aside form those obvious factors what else can i do? i definitely get much more vapor production than i do in any tank that i have but i still can't get HUGE clouds like i see a lot of other people getting. my micro coils are usually 6-8 wraps each

 

[thezoo]

Are you mouth inhaling or deep lung inhaling. Mouth to lung will not get you clouds
On a side note know when and where its cool to blow a fat cloud

 

[BeRight]

check out vapehappy on youtube - long lung hit - plus he shares his builds - I really like the "sleeper coil"

 

[BeRight]

Oh - Rip Trippers also likes the "sleeper coil' = dual coil on single strand of wire

 

[Ryan Kelly]

oh i only do lung hits. even on tanks. just always smoked that way

 

[Steam Turbine]

There is a trick to those big clouds you see on YouTube. Lighting is a big factor for the appearance of thickness.

 

[Froth]

There are lots of techniques for the huge clouds, lower and lower resistance, bigger and bigger air holes, 100% VG, etc etc. You have an Omega, so the 3mm air holes should do you pretty good. Personally, I find I blow the thickest clouds using straight over the counter VG, nothing added to it. There is no throat hit to speak of using only VG with no additives, so you can inhale as hard and long as you wish without coughing up a storm. I personally find that the way I inhale the vapor also plays a very big role in how much or how dense the vapor I exhale is. If I "carb" my mouth around the drip tip and also suck in a bit of air around the tip I find I get a larger cloud with more density.

Also...try some parallel coils, they're pretty popular with the cloud chasers around here.

 

[BeRight]

Only thing else I can think of is Maybe more airflow is needed - balance power with airflow - large bore mouthpiece try first if you haven't already - then you may need larger RDA top cap holes: This is assuming 100%VG/mechanical-DNA/fresh 30 amp high drain battery

Only thing after that I can think of is larger stronger longer lung hits - priming puffs first

 

[Froth]

Only thing else I can think of is Maybe more airflow is needed - balance power with airflow - large bore mouthpiece try first if you haven't already - then you may need larger RDA top cap holes: This is assuming 100%VG/mechanical-DNA/fresh 30 amp high drain battery

Only thing after that I can think of is larger stronger longer lung hits - priming puffs first

Ooh, I forgot that one - Yes, definitely get a larger bore mouthpiece with the largest possible through-hole.

 

[Unforeseen]

Moved to Assorted APV Discussions - Rebuildable Atomizer Systems