Cloupor dna 30 clone

[Souljah96786]

I have the Hana clone from cloupor and any build under one ohm the screen flashes at the resistance sign and it barely hit.. I thought this could handle builds at .3. Anyone else have this issue? Is this normal?


Sent from my iPad using Tapatalk

 

[PirateHooligan86]

I have the Hana clone from cloupor and any build under one ohm the screen flashes at the resistance sign and it barely hit.. I thought this could handle builds at .3. Anyone else have this issue? Is this normal?


Sent from my iPad using Tapatalk

I thought I had that issue at first too, but then I started running a couple different set-ups and I found out that the flashing is just letting you know that the VDC is really low based on your ohm and wattage combination. At .3 ohms and 30 watts, you're only running at 3 VDC. The blinking seems to occur anytime the equivalent voltage is at 3.7 VDC or below I believe. It will still fire, just letting you know that it's below their recommended VDC levels. Hope this helps!

 

[Equilibrium]

It's operating correctly. At .3 ohm you're asking it to buck down the voltage output which it can't do. It can increase the battery voltage but not reduce it.

There isn't any need to sub-ohm on the 30w device. IMO.. you'll get a much better vape if you build at 1.0 - 1.5 ohm and crank the wattage up.

 

[Souljah96786]

Thanks guys. Yea I don't sub ohm on this mod. I use a kayfun on it. Was trying out other attys and was curious. Thanks.


Sent from my iPhone using Tapatalk

 

[Asbestos4004]

Whatever do you mean, equilibrium??? Its a fact that you need to be .1 ohm or less to get big clouds!!! If you're not using welders gloves to hold your mod, you ain't vapin!!!

KIDDING! Equilibrium nailed it. I use kayfuns, taifuns and Lemo's on DNA 30's too....but build a 1.5 ohm dual coil in your dripper and run it at 25-30 watts. Its fantastic. I still like mechs and sub ohm builds (.3 - .5) but I don't do it near as much anymore.