Cobra, ZAP... Confussed...

[seahawkin]

So I got a Cobra had a rough time with set up, watched tons of videos and stalked these forms. Seemed I was doing everything right, but the vapor production was really low.

Got a Zap, watched those videos and boom holy vapor. So I applied the same learning to the cobra and still, really low vapor production.

Have others found that too or does the cobra need l33t status to turn it into a tasty chimney?

 

[donnah]

The air hole in the cobra is reported to be smaller than the zap. I have a did with a huge air hole and I get much more vapor out of it than I do my other rbas with smaller air holes.

 

[EDO]

This is going around with some of the latest Cobras.....they have obstructed air holes. Get a big needle and shove it in the air hole all the way and wiggle it around a bit. I was hardly getting any vapor until I did this. Now if you try it out and it doesn't improve the vapor at all, it might mean you aren't used to the Cobra and its stiffer draw. I blow clouds of vapor with mine.....very comparable to my other gennies. BUt it definitely took a few days to get used to the 1mm air hole.

 

[seahawkin]

Thanks, I made the hole a little bigger and it seems to be doing the trick. I am so pleased as it is such a good looken rba.