I've been vaping for a bit, I have more than a few set-ups. I just recently picked up on RDAs. My RDA set up is a kamry 100, Igo-w air holes drilled to 5/64", an EFEST 1600 mah 30a battery, 30 awg kanthal, grape juice ejuice that is 12 mg nicotine with a 5/95 pg/vg ratio courtesy of sunshine vape, and organic cotton for wicking material. I also have a multimeter, and ohms law calculator. My question is what is the best coil build and resistance for a great flavor, mellow throat hit and good cloud. Any suggestions?
Coil build on RDA?
- Thread starter Bsmith86
- Start date
- th_trl_thread_readers 0
- Status
The best build for you will depend on your preferences. What I like in my Trident dual coil RDA for great flavor and good cloud is two 1.6 ohm micro coils with 28 gauge Kanthal and coil wrapped on a 1/16 drill bit. I use cotton and am careful not to put too much in the coils. This build gives you 0.8 ohms total which your batteries can handle easily. I don't know about the TH since I don't use nic all the time and not much when I do. Your air holes will be on the big side for this build, but should not be too bad. If you build lower resistance the flavor can easily degrade but the vapor production will increase.
- Status
Similar threads
