Coil build

Status
Not open for further replies.

Ginger18704

Full Member
Aug 25, 2015
22
3
28
You're already at the upper echelon as far as power goes. Next thing to do would be to create more surface area. Dual parrallel coils are good start for that, just dont make them too wraps or you'll have trouble wicking.
So more or less wraps for more vapor? And can I do a sleeper build with parallel coils or should I do them separate
 

Ginger18704

Full Member
Aug 25, 2015
22
3
28
TBH, I dont know what a sleeper build is. All builds are under a top cap, and therefore hidden, making them sleepers? Amiright?

More wraps, more surface are, more vapor (if you can keep the wicking right).
When you don't have two seperet coils in your RDA I have one strand of wire for both of my coils I wrap one of them with a regular sized lead then the other lead is lager so after putting it in my negative post I can wrap coils with it on the other side makes my coils fire at exactly the same time
 

IMFire3605

Ultra Member
ECF Veteran
May 3, 2013
2,041
3,148
Blue Rapids, KS, US
I vape anywhere from 150-200 and with the sleeper coils I'm running .62 ohm

Bah, the never ending chase for the invisible rabbit. Only things I can suggest, wider diameter coil, cut out any excessive wicking that is restricting airflow. Other than what settings you are clearly exceeding, larger and larger clouds are not really what you got stuck in your head. Know I'm going to take a hit on this, but seriously tone it down. Last time I was chasing clouds on a mech with Nichrome80 24awg quad coils down at 0.18 felt like I was drowning in vapor, wasn't a very pleasant experience mind you, feeling like I couldn't breathe that well for about 5 or 10 minutes each time I hit that beast until the vapor had dissipated out of my lungs. To much is really sometimes to much man.
 
  • Like
Reactions: Ginger18704
Status
Not open for further replies.

Users who are viewing this thread