Coil builds for lower resistance?

[Kingrex00]

Hey I’m trying to find a build for coils, I’m using a 24 kanthal a1 wired and right now my coil is at .3 but I’d like to go down to a .2 or lower. I’m using the geekvape Zeus dual rta with the voopoo drag mod, thanks.

 

[Storm52]

Take a coil or two off.

 

[uthinkofsomething]

Make twisted wire with what you have. Two 5-6 wrap twisted 24g 2.5id coils would get you around .2 ohm. I prefer a little closer to .25 myself and usually go 6-7 wraps.

 

[sonicbomb]

@Kingrex00 With a regulated device like the Drag the coil resistance is not really important, the mod will deliver the selected wattage regardless. What you need to focus on is maximising surface area and minimising the overall mass of the coils.
Unless you are using super high power levels 24G is quite heavy. Using a lighter gauge wire like 26G will have better ramp up/down times, and being thinner means that it's cross section will have a better mass to surface area ratio.

Have a read of this -
Understanding the relationship between power and coil resistance | E-Cigarette Forum

What batteries are you using?

 

[VapourFlavour]

Hey I’m trying to find a build for coils, I’m using a 24 kanthal a1 wired and right now my coil is at .3 but I’d like to go down to a .2 or lower. I’m using the geekvape Zeus dual rta with the voopoo drag mod, thanks.

@sonicbomb is exactly right. Why are you worried about the .1 ohm difference when you can turn the wattage up?