Coil Head advice for kanger T2

[daviddavis]

Im new to vaping and I need to buy some replacement T2 coil heads. Im using a ego-T 650mah battery and want to know what resistance I need and why. Any help would be appreciated.

 

[Turbo311]

I was told by my local shop to stick between 2-2.5 ohms on the egos due to the voltage. If you go any lower you will burn through your battery much faster and the battery may think you have a short. Fwiw I run the 1.9-2.0 ohm heads on my 650 ego

 

[meli.]

HI DavidDavis,
Here is a thread with chart that may help you:
http://www.e-cigarette-forum.com/fo...ur-battery-temperature-preferences-excel.html
Chart:
Safe Vaping Power Chart

 

[hrlw817]

I use 1.8 ohm on my eGo 650 battery. Good vape, and my battery will last about 9 hours, and that's vaping close to 2ml during that time.

 

[ShogaNinja]

Vapor Alley and Discountvapers sell them but I honestly recommend you get the E1-V because the T2 Kanger's coil is so high that it heats up your drip tip and burns your lips. Doesn't that bother you?

Vapor Alley has the best price at 8 bucks for a 5 pack but they sometimes run out of stock. That's the word on the street. If that happens then DiscountVapers sells them too, for about 20 cents more per head.

The Twist is a 3.2v to 4.8 volt device. You should get 2-3 resistances (whatever's possible or what you want).
1.8ohm for low voltage (less than 4v) 2.2-2.4ohms for mid range (the low 4v range) and 3.0ohms for max voltage (4.8v only - going too much lower would be bad as vapor production/heat would suffer).

Kanger T2 Replacement heads