Coil Turning Habbits

[Davycrockett]

What do you use to make your atomizer coils?

 

[edyle]

I have a kuro, and a 'universal tools' coiler

$6.67 Universal Tools Wire Coiling Tool w/ Phillips & Slotted & Hex Key Screwdriver Bits - black / 3.5mm + 3.0mm + 2.5mm + 2.0mm winding rods at FastTech - Worldwide Free Shipping

 

[KentA]

Hand me my Coil Master & I'm a happy coiler.

 

[gandymarsh]

I have a very basic tool that works very well. It came with my Owl bottom feeder mod.

This is not exactly like it but it's similar. I clamp it in a tiny vise to use it.

 

[dhood]

Kuro Koiler works for me. Great for making the same coil over and over again. Really great when you need two coils as similar as possible when making a dual coil rig in an RDA.

 

[suprtrkr]

I have a coil master. I can't stand the miserable thing. I never have figured out how to use it. However, the clearly marked mandrels come in handy. They work about as well as the drill bits I used to use and are easier to hang on to if you put them in the handle.

 

[Robert Cromwell]

A drill bit.

 

[ElConquistador]

Artistic wire coiling gizmo

 

[speedy_r6]

different drill bits.

 

[Vaslovik]

I used a stick from a Q-tip for a long time, and it worked great for winding 26 kanthal 5/4 wrap .7 ohm coils.

 

[NoFumus]

screw driver or knitting needles (guages run in .25 mm increments from 2.0 up).

Lol, I thought the title of the thread was coil turning hobbits. Thought it might be some new gear from the shire.

 

[yuseffuhler]

screw driver or knitting needles (guages run in .25 mm increments from 2.0 up).

Lol, I thought the title of the thread was coil turning hobbits. Thought it might be some new gear from the shire.

What's..... coils, precious? You know, coils. Wrap em, burn em stick em in a mod.

 

[AXIOM_1]

I have several various sized Kuro coilers but the funny thing is I never use them. I usually just grab a small phillips head screwdriver and use that instead.

 

[Winchester]

It depends, Mostly the one's I make for some of my friends. You can leave this on the coffee table it will start a great conversation

 

[Steven G]

Also use the trusty old drill bit

 

[SomeTexan]

I've got a coil master and still end up using drill bits...

 

[AndriaD]

What do you use to make your atomizer coils?

A drillbit. These days, mostly a 3/32; still, occasionally a 7/64.

Andria

 

[GoBlue88]

Just ordered a set of screwdrivers, so that's what I will use.


Sent from my iPhone using Tapatalk

 

[coilburner]

Little screw driver that my rda came with

 

[Ryedan]

A set of precision screw drivers usually, but for odd sizes I use drill bits.