Here is a look at the Phoenix Clone Atomizer that many different vendor are selling these days. This atomizer is rebuildable and not hare to set up and use. I know many vapers out there are intimidated by using rebuildables, but like anything else, a little practice and it will get easier with time. I have found that the Phoenix is a very nice device for those who enjoy dripping. The vapor, throat hit, and flavor with the Pheonix will all be determined on how well the wick and coil is set up. What really intrigues me about using rebuildables, is the option to build a coil to what ohm you like vaping. If you like High Voltage vaping, you can build a Higher Ohm Atty, and if you are a Lower Voltage Vaper, then you can build a lower ohm atty. Building a different Ohm atty is all determined on how long, and what gauge wire you are using on your coil. This video is just showing how to do a basic setup of the Pheonix, and in the near future I will be going into more detail on building a different ohm atty.
Contest Giveaway Rules and Guidelines!!!!!!!
This Contest Giveaway is for a Phoenix Clone Atomizer with a 18in. piece of 3mm Silica Wick, and about 2ft of 32 A-1 AWG Kanthal to get you started with Rebuildables.
To Enter the Contest Giveaway, one must Subscribe to my YouTube Channel, AND Comment on this Video in the comment section here on YouTube.
THIS CONTEST IS FOR USA RESIDENTS ONLY!!!!!!!
The Contest Entries will no longer be accepted after September 30, 2012 at 11:59 pm EST. I will do another video of another device or accessory for vaping on or around Oct. 1, 2012, and I will include the drawing of the entries of the contest. The winner of the contest will then be responsible to contact me via email, and I will then ship out the winnings to them Free of charge.
Make sure you SUBSCRIBE and COMMENT ON THIS VIDEO!!!!
Last edited:
